Titration
Run acid from a burette into a pipetted sample of alkali, find the end point with an indicator, and calculate the unknown concentration.
- chemistry
- advanced
- 20 minutes
- Minutes
- 20
- Tasks
- 4
- Goals
- 3
- Badges
- 1
About this experience
What you will learn and do
Learning objectives
- Describe how a titration is carried out.
- Identify the end point using an indicator.
- Interpret a pH curve.
Skills you will build
- Precision
- Data interpretation
- Practical skills
Interactive practical
↑ Back to overviewVirtual lab · Chemistry
Set-up
Expected titre about 25.0 cm³.
Acid in the burette · base in the flask
Drag to rotate · scroll or pinch to zoom
Flow rate
Reaction HCl + NaOH → NaCl + H₂O
The flask holds 25 cm³ of 0.1 mol/dm³ NaOH, a strong base. It is fully ionised, so the pH is high (14 + log 0.1).
Strong acid + strong base: the salt does not react with water, so the pH is 7. Equivalence: 25.0 cm³ at pH 7.00.
An indicator is suitable when its colour change is sharp and happens right at the equivalence point. The table is worked out from the curve for HCl run into NaOH.
| Indicator | pH range | End point (cm³) | Change spread over | Verdict |
|---|---|---|---|---|
| Phenolphthalein | 8.2 to 10 | 24.99 (-0.01) | 0.05 cm³ | Suitable |
| Methyl orange | 3.1 to 4.4 | 25.09 (+0.09) | 0.38 cm³ | Suitable |
| Methyl red | 4.4 to 6.2 | 25.00 (+0.00) | 0.02 cm³ | Suitable |
| Bromothymol blue | 6 to 7.6 | 25.00 (+0.00) | 0.00 cm³ | Suitable |
End point vs equivalence point: the equivalence point is where the alkali is exactly neutralised. The end point is where the indicator changes colour. The figure in brackets is how far each end point is from equivalence.
Titre record
0 of 6 runsRecord the burette reading before you start and again at the end point. The titre is the final reading minus the initial reading. Make the first run a rough one, then repeat more carefully until two accurate titres agree within 0.10 cm³.
| Run | Initial | Final | Titre (cm³) | Colour |
|---|---|---|---|---|
| No runs yet. Your results will appear here. | ||||
Start with a rough titration: add the acid fairly quickly and stop when the colour changes.
Calculation practice
0 of 0 correct20.0 cm³ of sodium hydroxide solution was neutralised by 12.5 cm³ of 0.200 mol/dm³ hydrochloric acid. Calculate the concentration of the sodium hydroxide in g/dm³. (Na = 23, O = 16, H = 1)
Reaction: HCl with NaOH. 1 mL = 1 cm³.
Tasks
0 of 4 · 0 pts- Start the titrationNot completed yet
Add at least 10 cm³ of acid from the burette.
- Find the end pointNot completed yet
With methyl orange, stop as soon as the yellow flask turns orange.
- Try phenolphthaleinNot completed yet
Use phenolphthalein and watch the pink fade to colourless near the end point.
- OvershootoptionalNot completed yet
Add far more acid than needed and see what happens to the pH.
Check your understanding
0 of 20Finish the tasks to unlock the questions.
Experiment guide
- Rinse the burette with the acid and fill it. Note the initial reading.
- Pipette 25.0 cm³ of 0.1 mol/dm³ NaOH into the conical flask. Add 2 or 3 drops of indicator and stand it on a white tile.
- Run in HCl while swirling. Go drop by drop near the end.
- Stop at the first permanent colour change. Record the final reading and the titre.
- Repeat until two titres agree within 0.10 cm³.
Safety
- Wear a lab coat and safety goggles.
- Handle acids and alkalis with care. Never pipette by mouth.
- Rinse spills with plenty of water.
Key concepts
- Equivalence point
- Where the moles of acid and base are exactly in the ratio of the equation.
- End point
- Where the indicator changes colour. Close to, but not always exactly at, the equivalence point.
- Titre
- The volume run from the burette: final reading minus initial reading.
- Strong acid
- Fully ionised in water, so pH = −log[H⁺].
- Strong base
- Fully ionised.
Observations
| Acid (cm³) | pH | Colour |
|---|---|---|
| 0.0 | 13.00 | Yellow |
| 10.0 | 12.63 | Yellow |
| 20.0 | 12.05 | Yellow |
| 24.0 | 11.31 | Yellow |
| 25.0 | 7.00 | Yellow |
| 26.0 | 2.71 | Red |
| 30.0 | 2.04 | Red |
| 40.0 | 1.64 | Red |